0.85 Inch 128*128 IPS Super Small Square TFT LCD Screen Display SPI
4Wire Mini LcD Module Panel GC9107 12 Pin Soldering FPC
Pin Description:
| NO | Symbol | Description |
| 1 | GND | Power Ground |
| 2 | LEDK | LED Cathode |
| 3 | LEDA | LED Anode |
| 4 | VDD | Power Supply for Analog |
| 5 | GND | Power Ground |
| 6 | D/C | Display data/command selection pin in 4-line serial interface. |
| 7 | CS | Chip selection pin;Low enable,high disable. |
| 8 | SCL | This pin is used to be serial interface clock |
| 9 | SDA | SPl interface inputoutput pin.the data is latched on the rising
edge of the SCLsignal. |
| 10 | RESET | This signal will reset the device and it must be applied to
properly initialize thechip.Signal is active low. |
| 11 | GND | Power Ground |
NOTES:
1.DISPLAY TYPE:0.85”TFT
2.Viewing direction:ALL
3.Polarizer mode:Transmissive/normally black.
4.Driver IC GC9107.
5.Operating temp:-20°C~70°C
6.Stdeage temp:-30°c~80°c
7.Back light:1 chip-white led :20man,3.0v
8.LCM Luminance:330 C/M2(TYP)
9.Unmarked tolerance:±0.2
10.It is recommended that the window area of the case is 0.3mm larger
than the LCD A.A area. The product complies with ROHS standards
Backlight LCD Module
The backlight of our TFT LCD Module is made of white LED, which
provides a bright and clear display. This ensures that the images
and information on the display are easily visible in a variety of
lighting conditions.
General Precautions of TFT LCD Display
1. Safety
Liquid crystal is poisonous. Do not put it in your mouth. If liquid
crystal touches your skin or dlothes,
wash it off immediately by using soap and water.
2. Handling
The LCD panel is plate glass. Do not subject the panel to
mechanical shock or to excessive force on its surface.
The polarizer attached to the display is easily damaged. Please
handle it carefully to avoid scratch or other damages.
To avoid contamination on the display surface, do not touch the
module surface with bare hands.Keep a space so that
the LCD panels do not touch other components.Put cover board such as acrylic board on the surface of LCD panel
to
protect panelfrom damages.Transparent electrodes may be disconnected if you use the LCD panel
under environmental
conditions where the condensation of dew occurs.Do not leave module in direct sunlight to avoid malfunction of the
ICs.
3. Static Electricity
Be sure to ground module before tuming on power or operating
module.
Do not apply voltage which exceeds the absolute maximum rating
value 4. Storage Store the module in a dark room where
must keep at 25+10C and 65%RH or less.
Do not store the module in surroundings containing organic solvent
or corrosive gas.Store the module in an anti-electrostatic container or bag.
